MECHANICAL
01–10–25
01–10
Engine Workshop Manual 13B-MSP (Multi Side Port) (1773–1U–03C)
Revised 6/2008 (Ref. No. R108/08)
ECCENTRIC SHAFT BYPASS VALVE
CHU011011D01E04
Warning
• Engine oil temperature will increase during the inspection and become very dangerous. Be careful
not to burn yourself during the inspection.
1. Put the eccentric shaft bypass valve in a
container filled with engine oil.
2. Heat the container and verify that the projection
protrudes more than the minimum specification
when the engine oil temperature is 60 °C {140
°F}.
• If it is less than the minimum specification,
replace the eccentric shaft bypass valve.
Minimum projection
6 mm {0.24 in}
End Of Sie
ECCENTRIC SHAFT POSITION PLATE INSPECTION
CHU011011D01E05
1. Visually inspect the eccentric shaft position plate
for damage and erosion.
• If there is any malfunction, replace the
eccentric shaft position plate.
Eccentric shaft pulley tightening torque
14.2—17.2 N·m {1.45—1.75 kgf·m, 10.5—12.6
ft·lbf}
End Of Sie
MAIN BEARING OIL CLEARANCE INSPECTION
CHU011010E00E01
1. Using a micrometer, measure the outer diameters
of the inside main journal.
2. Using a cylinder bore gauge, measure the inner
diameter of the stationary gear main bearing.
PROJECTION PART
VERNIER CALIPER
CHU0110E057
ECCENTRIC SHAFT
POSITION PLATE
BHJ0110E106
INSIDE
INSIDE
OUTSIDE
OUTSIDE
CHU0110E022
BHJ0110E056
Komentáře k této Příručce